Download
Share
Print this page
SFA SANITOP Installation And Care Instructions
  1. Manuals
  2. Brands
  3. SFA Manuals
  4. Water Pump
  5. SANITOP
  6. Installation and care instructions

SFA SANITOP Installation And Care Instructions

Hide thumbs Also See for SANITOP:
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual See also: Instruction and Installation Manual
THESE INSTRUCTIONS MUST BE READ BEFORE INSTALLATION IS ATTEMPTED. FAILURE TO DO SO MAY COMPROMISE WARRANTY. FOLLOWING
INSTALLATION PLEASE LEAVE ALL PAPERWORK WITH CLIENT AS IT CONTAINS IMPORTANT INFORMATION ON HOW TO UNDERTAKE ONGOING
CARE FOR YOUR SANITOP PUMP TOGETHER WITH WARRANTY PAPERS.
1. Description
1. Description -
- THIS UNIT IS FOR DoMesTiC Use oNLY
THIS UNIT IS FOR DOMESTIC USE ONLY
The Sanitop
is a compact macerator pump designed to receive and pump away sewage waste and water from one standard P-trap WC pan
alone or together with one vanity basin.
Sanitop
Please pay particular attention to the following:
Possible danger to personnel
"ATTENTION" This is a general warning that failure to follow instructions could result in poor functioning of the unit.
this new generation of appliances, it is important to comply with the installation instructions in section 5, 6 and 7.
2. List of Accessories included
A
A
Discharge elbow
e
E
Smaller
diameter
towards
pump casing
Inlet Connector
i
I
Smaller
diameter
towards
pump casing
Pan Collar and Cable Tie
SANITOP PAGE 1
iNsTALLATioN AND CARe iNsTRUCTioNs
INSTALLATION AND CARE INSTRUCTIONS
x1
B
B
Hose clip
x1
F
F
Smaller
diameter
towards
pump
100mm
casing
Hose clip
x1
Warning of possible electrical hazard
x4
C
C
32 x 55
Hose clip
x1
G
G
90 x 110
Floor mounting bracket
x1
D
D
25 x 40
Hose clip
x2
H
H
Foam feet
x1
20 x 32
x4

Advertisement

loading
Need help?

Need help?

Do you have a question about the SANITOP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for SFA SANITOP

Summary of Contents for SFA SANITOP

  • Page 1 THESE INSTRUCTIONS MUST BE READ BEFORE INSTALLATION IS ATTEMPTED. FAILURE TO DO SO MAY COMPROMISE WARRANTY. FOLLOWING INSTALLATION PLEASE LEAVE ALL PAPERWORK WITH CLIENT AS IT CONTAINS IMPORTANT INFORMATION ON HOW TO UNDERTAKE ONGOING CARE FOR YOUR SANITOP PUMP TOGETHER WITH WARRANTY PAPERS. 1. Description 1.

  • Page 2: Performance Curve

    1:100 fall Install Isolation Valve at beginning of pipe run metres Following vertical lift, increase discharge pipe diameter by one size on the Horizontal run to Sewer or vent connection. N.B. VERTICAL LIFT MUST PRECEDE HORIZONTAL RUN SANITOP PAGE 2...

  • Page 3: Installation

    6. Installation TO BE UNDERTAKEN BY A REGISTERED PLUMBER IN CONJUNCTION WITH: AS3500 10:10 • The Sanitop should be installed to allow full access in the event that servicing and or removal is necessary. Sanitop movement during operation. • The Sanitop must be coupled directly to the spigot (outlet) of the P-trap WC pan.
  • Page 4 • Horizontal pipework ( following initial vertical lift ) can be upgraded by one size to 25mm. • Once selection has been made, insert discharge elbow (supplied) into the rubber discharge pipe protruding from lid of the Sanitop, trim rubber connector to size and make connection between discharge elbow and upvc discharge pipe.
  • Page 5 AS 3500 10:10 & 6:7:4. • You can use suitable pvc pipe or plastic hose to run the vent, either to the open atmosphere or to an existing vent stack located nearby. Sanitop pod is recommended approximately every 12 months. SANITOP PAGE 5...

  • Page 6: Electrical Connection

    Periodical servicing may be required, depending on your usage cycle. On average we would recommend that a service be undertaken every workplace or domestic environs (NoHsC 2004-2009) 2 years or alternatively if you believe that your Sanitop is not functioning as it has been, then give our Technical department a call to obtain details of your nearest Service Agent.
  • Page 7 Periodical servicing may be required, depending on your usage cycle. On average we would recommend that a service be undertaken every 2 years or alternatively if you believe that your Sanitop is not functioning as it has been, then give our Technical department a call to obtain details of your nearest Service Agent.
  • Page 8 14. Parts White casing SANITOP PAGE 8...
  • Page 9 In ALL CASES Position the Saniflo unit directly behind the toilet pan, supply must be protected by a 30mA RCD rated at 16A. not underneath it. After sales contact information: info@saniflo.com.au SANITOP PAGE 9...