Toto GR TLG02301U Installation And Owner's Manual page 5

Drain
4. Remove the plunger, flange and
gasket from the drain assembly by
unfastening the flange and pulling
these parts from the drain.
Insert the drain body up thorugh the
drain hole from below the lavatory. If
necessary, turn the nut and push the
washer and gasket (thick) down to
allow for clearance.
While holding the drain body in
place, fasten the flange to the drain
body from the top. Ensure that the
gasket is between the flange and
the lavatory as shown. Once the
flange is fully seated, turn the nut
below the lavatory up until a good
seal is formed. Do NOT overtighten!
Reinsert the plunger if needed.
INSTALLATION PROCEDURE
Flange
Gasket
(thick)
Tail pipe
5
Plunger
Gasket
Washer
Nut
Body
Lever
screw
hole