Table of Contents
Advertisement
slot and 'B' bracket must match 'B' slot.
9
MOVE INTO THE CAVITY
2
10
SECURE THE DRAWER
1
Open the drawer halfway.
Using a flat-bladed
screwdriver, prise the plastic
gray plug out of the trim
moulding.
2
1
Ensure hoses and cord
are not kinked or twisted.
Using a small Philips screwdriver,
screw through the trim moulding,
securing the side mounting
bracket to the cabinetry. Do not
damage the rubber trimseal.
2
3
Replace the plastic
gray plug back into
the trim moulding and
ensure the trimseal is
facing forward.
Repeat for all four brackets.
3
9
SECURE THE DRAWER
The product has three pairs
of fixing points:
4
(Refer to
for relevant parts)
Ensure the sound insulation
is repositioned correctly.
a pair of fixing holes either side on the
bottom
(use 1½ " (38 mm) fixing screws & washers)
10
REFIT THE DRAWER
Ensure the drawer is
now rotated
clockwise back.
5
1
Ensure the drawer clips on
both sides click into place.
1
two pairs of formed
brackets on either side
2
of the chassis
(use 5⁄8" (16 mm) screws)
3
4
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
2
5
2
Advertisement
Table of Contents
