ABB ScreenMaster RVG200 Commissioning Instructions page 14

6.7 Change the channel configuration
1. At the System Configuration page, press the Channels
icon to display the I/O Groups 1(6) Channels page.
2. Press the icon associated with the required Group 1 (6)
Channels (for example
...06) dialog.
Note. Use the
different Channels in the same process group.
Setup
3. Press the
associated with each field to enter and configure Setup
parameters – press
field.
4. Repeat for all other tabs on the Channel 1.01 (1.06) dialog
and for all other required channels.
When all fields have been configured, press
to the I/O Groups 1(6) Channels page then
to the System Configuration page.
5. Proceed to the next step (6.8) to set up the inputs /
outputs (I/O).
6.8 Set up the inputs / outputs (I/O)
1. At the System Configuration page, press the I/O icon
to open an I/O page displaying fitted I/O modules.
Note. I/O modules are detected automatically.
2. Press the icon associated with the required module to
display the dialog and fields associated with that module.
3. Configure parameters for each required module.
4. When all parameters have been configured, press
return to the I/O page then
Configuration page.
5. Proceed to the next step (6.9) to exit Configuration level
and save changes.
14
) to display the Channel 1 (01
arrows to select
tab and then the
to accept the content at each
to return
to return
to return to the System
6.9 Save current configuration and exit
1. Press at the System Configuration page – a prompt
is displayed with options to Apply Changes, Export
Configuration, Return to Configuration Mode or Discard
Changes:
System Configuration
Apply Changes
Export Configuration
icon
Return to Configuration Mode
Discard Changes
2. Press Apply Changes (
configuration and return to the Operator page.
3. Proceed to the next step (6.10) to start recording.
6.10 Start recording (archiving)
1. Open the media door and insert the external media card
and close the door.
Recording is initiated automatically.
to
Note. Alternative archive media can be used –
refer to the Operating instructions (OI/RVG200-EN)
for compatible media types.
) to save the current
CI/RVG200–EN