Sony MEX-DV2000 Installation/Connections page 2

Parking brake switch cord
Parking brake switch cord
1 2
Orient the release key
correctly.





1
2
1 8 2
m m
5 3 m
m
 Claws
A B
1
2
• Choose the installation location carefully so that the
• Avoid installing the unit in areas subject to dust, dirt,
• Use only the supplied mounting hardware for a safe
Adjust the mounting angle to less than 45°.
Be sure to connect the parking cord (Light green) of 
to the parking brake switch cord. The mounting position
of the parking brake switch cord depends on your car.
Consult your car dealer or your nearest Sony dealer for
further details.
Connection example
Notes
• Whether in use or not, route the MIC input cord such that it
• The Karaoke function is unavailable while driving.
Before installing the unit, remove the protection
collar  and the bracket  from the unit.
1
Face the hook inwards.
2
 
Installation in the dashboard
Notes
• Bend these claws outward for a tight fi t, if necessary (-2).
• Make sure that the 4 catches on the protection collar  are
Before installing the unit, detach the front panel.
3

Before detaching the front panel, be sure to press .
Press , then slide the front panel to the right, and
gently pull out the left end of the front panel.
Dashboard

Place the hole  of the front panel onto the spindle 
Fire wall
on the unit, then lightly push the left side in.



Be sure to set the Auto Off function. For details, see the
supplied Operating Instructions.
The unit will shut off completely and automatically in
the set time after the unit is turned off, which prevents
battery drain.
If you do not set the Auto Off function, press and hold
  until the display disappears each time you turn
the ignition off.
When the installation and connections are completed,
be sure to press the RESET button with a ball-point pen,
etc., after detaching the front panel.

A
B
Precautions
unit will not interfere with normal driving operations.
excessive vibration, or high temperature, such as in
direct sunlight or near heater ducts.
and secure installation.
Connecting the parking brake
cord

Connecting a microphone
does not interfere with driving. Secure with a cord clamp, etc.,
if the cords are installed around your feet.
Removing the protection collar
and the bracket
Пpимeчaния
Remove the protection collar .
 Engage the release keys  together with the

protection collar .
 Pull out the release keys  to remove the

protection collar .
Remove the bracket .
 Insert both release keys  together between
  
the unit and the bracket until they click.
 Pull down the bracket 
, then pull up the unit 1 
 
to separate.


Mounting example
 
2 



 
properly engaged in the slots of the unit (-3).
How to detach and attach the
front panel
Пpимeчaния
(-2)

(-3)
Warning if your car's ignition
has no ACC position






RESET button

Auxiliary power connector may vary depending on the
car. Check your car's auxiliary power connector diagram
to make sure the connections match correctly. There are
three basic types (illustrated below). You may need to
switch the positions of the red and yellow leads in the car
stereo's power supply lead.
After matching the connections and switched power
supply leads correctly, connect the unit to the car's
power supply. If you have any questions and problems
connecting your unit that are not covered in this manual,
please consult the car dealer.
Auxiliary power connector
Red
Red
Yellow Yellow
Yellow continuous power supply Red switched power supply
4 7
Red Red
Yellow Yellow
Yellow switched power supply Red continuous power supply
4 7
Red Red
Yellow Yellow
the car without ACC position