KTM 1190 RC8 R EU/UK 2013 Setup Instructions page 9

3 WORK
3.2 Removing the seat
3.3 Mounting the passenger seat
3.4 Fitting the seat
–
Position the distance sleeve.
–
Mount and tighten screw
Guideline
Remaining frame bolts
–
Tighten screw
Guideline
Screw, handlebar stub
600986-11
–
Repeat the adjustments on the other handlebar stub.
–
Carefully move the handlebar to and fro over the entire steering range.
» If a component restricts the freedom of movement of the steering or comes
into contact with the trim:
–
–
Insert the ignition key in the seat lock
–
Raise the rear of the seat, push it towards the rear, and remove it upwards.
B01308-11
Warning
Danger of accidents The passenger seat can come loose from the anchoring
if it is not mounted correctly.
–
–
Position the passenger seat in the space provided.
–
Press down the passenger seat until it clicks into place.
–
Finally, check that the passenger seat is correctly mounted.
B01326-01
–
Position the recesses of the seat to the lugs on the frame, lower the rear end and
simultaneously push it forward.
–
Lock the seat by turning the ignition key in the seat lock.
–
Remove the ignition key from the seat lock.
–
Finally, check that the seat is correctly mounted.
B01323-10
.
2
.
1
Establish freedom of movement and reposition the component.
After mounting the passenger seat, check that it is locked correctly by
pulling up.
M5 5 Nm (3.7 lbf ft)
M8 20 Nm
(14.8 lbf ft)
and turn it clockwise.
1
7