Table of Contents
Advertisement
2
SETUP
2.1
Unpacking and setting up the vehicle
Preparatory work
–
Remove the carton.
Main work
–
Remove the adhesive tape in the upper area of the motorcycle.
201904-10
–
Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking, leave the other films
on the vehicle until you have finished work on the vehicle.
–
Remove the separate enclosure from the seat.
–
Unpack the separate enclosure and check that it is complete based on the enclo-
sure list.
–
Check the vehicle for transport damage.
201905-10
–
Remove screw
–
Adjust the handlebar height/position. (
Info
Mount the handlebar stubs in the low position.
201906-10
–
An assistant holds the motorcycle.
–
Remove screws
–
Remove nut
–
Remove the retaining bracket and threaded rod on both sides.
–
Push the motorcycle off of the pallet.
201907-10
–
Mount the reflector.
201901-10
with the distance sleeve from both handlebar stubs.
1
of the retaining bracket on both sides.
2
.
3
p. 5)
3
Advertisement
Table of Contents
