Fault in the AutoDos (automatic dispensing)
Problem
The message
Insert PowerDisk. Deactiv-
ate AutoDos with OK
pears in the display.
The optical in-operation
indicator light is flash-
ing quickly.
The alarm tone is
sounding.
The programme does
not start or a pro-
gramme that has
already started stops.
The message
AutoDos lid
appears in the dis-
open
play
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK.
pears in the display.
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK.
pears in the display
even though you have
inserted a new
PowerDisk.
Cause and remedy
The AutoDos function is active but no PowerDisk has
been inserted.
ap-
Insert a PowerDisk (see the "Detergent" chapter,
"Automatic dispensing/AutoDos" section).
If you do not wish to use automatic dispensing,
deactivate the function using OK.
The AutoDos lid has not been closed properly.
Close the AutoDos lid and lock it fully (see "Deter-
gent" chapter, "Automatic dispensing/AutoDos"
section).
If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see "Detergent"
chapter, "Inserting a PowerDisk" section).
If the same fault message appears again, call the
Miele Customer Service Department.
The AutoDos function is active and the PowerDisk is
empty.
ap-
Replace the PowerDisk (see the "Detergent"
chapter, "Automatic dispensing/AutoDos" section).
If you do not wish to use automatic dispensing,
deactivate the function using OK.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not re-
ap-
cognised the new PowerDisk.
Switch the dishwasher on before replacing the
PowerDisk (see the "Detergent" chapter, "Auto-
matic dispensing/AutoDos", "Inserting a
PowerDisk" section).
Problem solving guide
87