Troubleshooting - LG LAS160B Owner's Manual

16

Troubleshooting

Troubleshooting
PROBLEM
The unit does not
work properly.
No Power
No sound
4
The remote control
does not work
properly.
The AUTO POWER
function does not
work.
When you feel the
output sound of the
unit is low.
y Turn off the power of this unit and the connected external device (TV, Woofer,
DVD-player, Amplifier, etc.) and turn it on again.
y Disconnect the power cord of this unit and the connected external device (TV,
Woofer, DVD-player, Amplifier, etc.) and then try connecting again.
y Previous setting may not be saved when device power is shut off.
y The power cord is unplugged.
Plug in the power cord.
y Check the condition by operating other electronic devices.
y Incorrect input source is selected.
Check the input source and select the correct input source.
y The mute function is activated.
Press (Mute) or adjust the volume level to cancel the mute function.
y When you are using connection with a external device (set top box, Bluetooth
device etc.), adjust volume level of the device.
y The remote control is too far from the unit.
Operate the remote control within about 7 m.
y There is an obstacle in the path of the remote control and the unit.
Remove the obstacle.
y The batteries in the remote control is exhausted.
Replace the batteries with new one.
y Check connection of the external device such as TV, DVD/Blu-Ray player or
Bluetooth device.
y Depending on the connected device, this function may not operate.
Check the details below and adjust the unit according to them.
y Switch [ON] state of DRC function to [OFF] by using remote controller.
y With the sound bar connected with TV, change the AUDIO DIGITAL OUT setting on
TV Setup Menu from [PCM] to [AUTO] or [BITSTREAM].
y With the sound bar connected with Player, change the AUDIO DIGITAL OUT setting
on Player Setup Menu from [PCM] to [PRIMARY PASS-THROUGH] or
[BITSTREAM].
y Change Audio DRC setting on Player setup menu to [OFF] state.
CAUSE & CORRECTION