Knaack MONSTER BOX Series Instruction And Repair Parts Manual page 5

RECHARGING POWER TOOLS IN YOUR MONSTER BOX™
POWER PASS™ electrical pass through (included):
The Job Site models listed in the previous section have a pre-determined
mounting area suggested for use with the POWER PASS electrical
pass through or the Accessory Resident Power Supply Box (purchased
separately).
Knockout removal :
1. Choose the desired location and secure a hammer or mallet.
2. Using a mallet, strike the knockout feature until it breaks free of the
sheet metal wall. Twist the plug from wall with pliers, if necessary.
3. Ensure all sharp edges are removed. Insert the included grommet to
ensure power cords are protected from raw sheet metal edges.
Extension Cord-
• Follow all Extension Cord manufacturer's Warnings and Instructions.
• After removing knock-out, insert rubber hole protector. Do Not insert extension cord through hole without protector
in place.
• Only use a three-wire extension cord with all three prongs intact. Never remove the round grounding prong.
• Extension cord must be connected to a 120 Volt GFCI protected outlet with proper ground. If GFCI outlet is not
available, use an extension cord with GFCI protection built in.
• Check the insulation and plugs of extension cord before using. Do Not use cord if it is worn or damaged.
• Do Not overload extension cord.
• Remove extension cord from the hole before moving or transporting storage chest.
• An extension cord not marked for Outdoor Use must only be used Indoors.
• Do Not connect extension cord to outlet that also supplies critical safety equipment with power.
Cordless Power Tool Battery Chargers-
• See Charger's Owner's Manual for proper use and care of charger and batteries. Follow all Warnings and
Instructions provided with your battery charger.
• Place chargers and electrical connections in tray.
• Chargers are Dry location use only. Do Not expose to liquid, vapor, or rain. Should your charger become wet, Do
Not attempt to use. Unplug extension cord from supply before handling wet charger or cords.
• Only use chargers and batteries that are intact and operating properly.
• Do Not touch metal prongs when plugging charger into extension cord.
• Keep flammable materials like paper or rags away from charger, cords or connections.
• Do Not place or attempt to charge lead acid, car type batteries in storage chest.
Accessory Resident Power Supply
The Accessory Resident Power Supply Box can be used with any KNAACK® Job Site Storage Equipment as well as other
manufactures of job site equipment. Some job site storage equipment manufactured from 2007 and beyond incorporated
knockout features in the container walls to readily accept the Accessory Resident Power Supply box. All other models
require punching and drilling mounting holes to accommodate the option.
Note: Follow installation instructions included in the Accessory Resident Power Supply Box kit for mounting this option to
your Job Site Box
Suggested use:
The Accessory Resident Power Supply Box can supply simultaneous power to (4) devices so long as the cumulative
drawn amperage is 15 amps or less. Typically, this will allow continued charging of battery cells (for tools) in conjunction
with medium duty tool operation at the job site box.
WARNING
Coming in 2008
5