Advertisement
11. The relative position with the motor plate P4 and the plate
P1. Plate P4 is symmetrically arranged. Please pay attention to
the installation position of the stepper motor M1 on the plate
P4 in the frame line.
13. The position of P5L, P5R. Motor wire M3 and N2 is showed
above. M3 need to pass through the middle cavity of P5L, P5R
and F1, and note that 4PIN is left on the left while 6PIN is left
on the right. N2 should be slide into the left end of F1 and it
will be used to fastening C2.
15.N2 should slide into the lower bottom of F3, and will be
used to fastening the main control C1
12.
Please install M2 on M1 first, and pay attention to the
position of M2.The gap between M2 and M1 is about 1mm
and ensure that the synchronous belt remains level.
install M1 on P4, and notice that the position of stepper motor
on P4 should be symmetrical.
14. Install the left P5L, F3, etc. Notice that N2 should slide into
F1 and F3 in advance, and notice that 4Pin of the motor wire
M3 should be left here.
16. Install the right P5R, F3, etc. Notice that N2 should slide
into F3 in advance, and notice that 6Pin of the motor wire M3
should be left here.
5/9
Then,
Advertisement
