Advertisement
Connected
R.A. GoTo
4-pin
motor cover
rectangular
connectors
Figure 7. R.A. GoTo motor wiring
Brass gear
Setscrew
Dec. worm
gear shaft
Figure 8. Correct orientation of brass gear for Dec. axis
Figure 9. The Dec. GoTo motor cover
Note: There is a small packet of grease included with your
SkyView Pro GoTo system. Once you have installed the GoTo
motor so the gears mesh properly, you can apply a very
small amount of the included grease to the meshed gears to
ensure optimal gear mating.
Attaching the Dec. GoTo Motor
Before attaching the Dec. GoTo motor drive, the telescope
tube must be removed from the equatorial mount.
R.A.
GoTo
motor
Figure 10. The Dec. GoTo motor assembly
1. Remove the Dec. slow-motion control knob from the Dec.
2 Using the supplied Phillips-head screwdriver remove the
3. Slide the geared end of the remaining small brass gear
Philips head screws
Figure 11. The location of the flange on the mount
Figure 12. Attaching the Dec. GoTo motor
Smaller
gear
Dec. GoTo motor
attachment screw
worm gear shaft. The Slow-motion knob will not be usable
once the SkyView Pro GoTo system has been installed.
All slow-motion adjustments will be made using the GoTo
hand controller.
Dec. Motor cover from the Dec. motor assembly (Figure
9). Once the screws have been removed pull the cover
off the motor. There will be some friction resistance but it
should pull off by hand. Save the cover and screws in a
safe place to reinstall after the motor is attached.
onto the Dec. worm gear shaft of your SkyView Pro mount
4mm hex key
Flange
Attachment hole
Flange
Hole
Dec. GoTo motor
5
Advertisement
