Reflector Mounting; Power Connection; Radio Settings - Profoto ProDaylight 200Air User Manual

reflector mounting

1. Unlock the clasp on the reflector.
2. Slide the reflector onto the ProDaylight Air unit. Use the Zoom Scale [6] to place the
reflector in the desired position.
3. Secure the reflector by locking the clasp.

Power connection

1. Connect the Lamp Cable [3] to the Lamp Connector [A] on the ProBallast 200/400 by
aligning the white dots on the cable plug with the white dot on the ballast panel. Secure
by turning the ring on the plug clockwise.
14
2. Connect the AC mains cable to the Power Connector [C] on the ProBallast 200/400 and
to the mains power supply outlet.
3. The Power Indicator [E] will be red, indicating that the ballast is receiving power but is
in standby mode.
4. Press the On/Off Button [D] to turn on the ProBallast 200/400 and the ProDaylight Air
unit.
5. The Power Indicator [E] will now be green.

radio settings

1. Press the Channel Set Button [H]. The Display [F] will start flashing, showing the current
radio channel number to the left and the radio group letter to the right, or "off" if the
radio transceiver is switched off.
2. While the Display is flashing, turn the Setting Knob [G] to switch on/off the radio
transceiver and to select radio channel number (off, 1, 2, 3, 4, 5, 6, 7, 8):
• Turn the Setting Knob [G] clockwise to switch on the radio transceiver and increase
the radio channel number.
• Turn the Setting Knob [G] counter-clockwise to decrease the radio channel number
and to switch off the radio transceiver.
3. While the Display is flashing, press and hold down and turn the Setting Knob [G]
clockwise to increase the group letter (A, B, c, D, E, f) and counter-clockwise to
decrease the letter.
4. Wait until the Display [F] stops flashing. (The Display will now show the light intensity.)
www.profoto.com