Page 1
FLEXTOOL RIDE ON TROWEL FP836 O P E RA TING I N S T RU C T I ON S WARNING To reduce the risk of injury, all operators and maintenance personnel must read and understand these instructions before operating, changing accessories, or performing maintenance on this power equipment.
CONTENTS FUNCTIONS AND CONTROLS Introduction The trowel machine reproduces the action of hand trowels while giving a high quality dense finish with wear resistance. The angle of Applications the blades is adjustable during operation from a floating position, with the full blade area in contact to flatten the surface, to a Function and Controls finishing position with the blades tilted to give a finished surface.
10. Blades – Combination blades, floating blades and finishing DO NOT overfill the fuel tank and avoid spilling petrol or diesel when blades can be fitted with the trowel. refuelling. Spilled petrol and diesel or petrol vapour may ignite. If spillage occurs, ensure that the machine is dry before starting the 11.
OPERATION For straight line movements (forward and reverse) move the handles in the same direction you wish to travel. BEFORE OPERATION Move the handles in the opposite directions to produce rotation on The following items should be checked on a daily basis before the machine axis.
Please book your machine with a hump, move the unit back and forth over the hole or hump. More a Flextool service co-ordinator to arrange for the no charge 25 passes may be needed for the desired surface finish.
CARE AND PREVENTIVE MAINTENANCE TROUBLESHOOTING ENSURE repairs and maintenance of the trowel machine is performed only by qualified personnel. SYMPTOM POSSIBLE CAUSES AND CAUTION: Make sure the engine is shut down, isolated and cool CORRECTION enough before performing repairs and maintenance. Motor does not start ...