JVC KD-SR72 Instruction Manual page 12

AUDIO SETTINGS
AUDIO
BASS BOOST +01 — +05 (+01): Selects your preferred bass boost level. ;
OFF: Cancels.
LOUD 01 / 02: Boosts low or high frequencies to produce a well-balanced
sound at low volume. ; OFF: Cancels.
SUB.W LEVEL * 4 SPK-OUT * 5
PRE-OUT * 6
SUB.W * 6
ON / OFF: Turns on or off the subwoofer output.
SUB.W LPF * 4
THROUGH: All signals are sent to the subwoofer. ; LOW 55HZ /
MID 85HZ / HIGH 120HZ: Audio signals with frequencies lower than
55 Hz/ 85 Hz/ 120 Hz are sent to the subwoofer.
SUB.W PHASE * 4
REVERSE (180°)/ NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[SUB.W LPF].)
FADER R06 — F06 (00): Adjusts the front and rear speaker output balance.
BALANCE *
7
L06 — R06 (00): Adjusts the left and right speaker output balance.
VOL ADJUST –15 — +06 (00): Preset the initial volume level of each source
(compared to the FM volume level). Before adjustment, select the
source you want to adjust. ("VOL ADJ FIX" appears if FM is selected.)
AMP GAIN LOW POWER: Limits the maximum volume level to 25. (Select if
the maximum power of each speaker is less than 50 W to prevent
damaging the speakers.) ; HIGH POWER: The maximum volume level
is 35.
12
00 to +06 (+03): Adjusts the output level of the
subwoofer connected via speaker lead. ( 21)
–08 to +08 (00): Adjusts the output level of the
subwoofer connected to the lineout terminals (REAR/
SW) through an external amplifier. ( 21)
D.T.EXP ON: Creates realistic sound by compensating the high-frequency
(Digital Track components and restoring the rise-time of the waveform that are lost in
Expander) audio data compression. ; OFF: Cancels.
TEL MUTING * 8
ON: Mutes the sounds while using the cellular phone (not connected
through KS-BTA100). ; OFF: Cancels.
SPK/PRE OUT Depending on the speaker connection method, select the appropriate
setting to get the desired output. ( 13, Speaker output settings)
* 4
Displayed only when [SUB.W] is set to [ON].
* 5
Displayed only when [SPK/PRE OUT] is set to [SUB.W/SUB.W].
* 6
Displayed only when [SPK/PRE OUT] is set to [REAR/SUB.W] or [SUB.W/SUB.W].
* 7
This adjustment will not affect the subwoofer output.
* 8
Does not work if [BT ADAPTER] is selected for [AUX] in [SRC SELECT]. ( 4)