Using The Keypad - Genie Wireless Keypad Instructions Manual

Programming the Opener
(continued)
THIS IS AN EXAMPLE ONLY. ENTER YOUR OWN PIN IN STEP 2.
Up/Down key
Opener
Up/Down key
Up/Down key
NOTE: Pressing any key will stop or start the opener while the door is in
motion. The door will automatically stop fully open or closed. When the
door has stopped moving, pressing on any single button will activate door
until backlight goes off (30 seconds).
NOTE: Rapid blinking of the red LED on the Powerhead indicates an error.
When the blinking stops, you must start programming steps over.
For multiple doors only
(continued)
YOU MUST BEGIN AGAIN AT "PROGRAMMING THE OPENER" —
FOR EACH DOOR.
THIS IS AN EXAMPLE ONLY. ENTER YOUR OWN PIN IN STEP 1.
Up/Down key
or or
Opener
Up/Down key
Up/Down key
MUST
NOTE: Pressing any key will stop or start the opener while the door is in
motion. The door will automatically stop fully open or closed. When the
door has stopped moving, pressing on any single button will activate door
until backlight goes off (30 seconds).
NOTE: Rapid blinking of the red LED on the Powerhead indicates an error.
When the blinking stops, you must start programming steps over.
THIS IS AN EXAMPLE ONLY. ENTER YOUR OWN PIN IN STEP 1.
O O p p e e n n r e r e
For multiple doors only
THIS IS AN EXAMPLE ONLY. ENTER YOUR OWN PIN IN STEP 1.
Mounting Keypad
The keypad MUST be mounted within sight of the garage door(s)
Opener
at least 5 feet above the floor and clear of any moving door part.
Screw
head gap
MUST
Using The Keypad
Up/Down key
or or
Up/Down key
1/8"
Wall
(Continued other side)
3