Edit Units - Televic Confidea G3 Installation & User Manual

5. To add a unit to the initialization list, press the microphone button of the unit (this is the
button with the following icon
6. The LEDs will turn green indicating that the unit is added to the initialization list. Per unit the
following information is shown:
Parameter
Name
Chairman icon
Serial number
Battery life
Packet loss (quality)
7. Repeat step 5 until all units are added.
8. Click Close initialization to save the setup. Only those units that were initialized are visible in
the Initialization list and are available to join the conference. This list remains available on
the WCAP, even when WCAP is switched off and on again.
Figure 4: manually initializing units. The battery icon shows the remaining battery life of the unit.

5.1.3. Edit units

Once units are linked to the WCAP it is possible to edit some of the features of the units. You can
change the name, create groups and add units to specific groups.
1. Click Edit configuration.
2. Click the edit icon
USER GUIDE – Confidea G3
.
to change the name and press ENTER when ready.
Description
Name of the unit, can be edited
A start icon indicates that this unit has chairman
capabilities.
The serial number of the unit
Shows the remaining battery life of the unit
Shows the number of packets lost during
transmission, this affects the quality of the
sound. The higher the number, the lower the
quality.
20