Sony HVR-V1E Operating Manual page 76

Press the MENU button t select the
dial.
b Notes
• This function is effective only when the AUTO/
MAN switches of both CH1 and CH2 are set to
MAN (p. 48).
• When [LINKED] is set, you can adjust the
volume with the AUDIO LEVEL dial of CH1
(p. 48).
INPUT1 LEVEL
x
You can switch between microphone and
line for input from the INPUT1 jack.
B MIC
Select to input audio signals from an
external microphone through the INPUT1
jack
.
appears on the status check screen.
LINE
Select to input audio signals from an audio
device through the INPUT1
appears on the status check screen.
INPUT1 TRIM
x
You can adjust levels of signal input from
the INPUT1 jack. This function is effective
only when [INPUT1 LEVEL] is set to
[MIC].
You can select from [0dB], [-8dB] and [-
16dB] (the default setting is [0dB]).
INPUT1 WIND
x
This function is effective only when
[INPUT1 LEVEL] is set to [MIC].
B OFF
Select to disable wind noise reduction.
ON
Select to enable wind noise reduction.
appears on the status check screen.
INPUT2 LEVEL
x
You can switch between microphone and
line for input from the INPUT2 jack.
B MIC
Select to input audio signals from an
external microphone through the INPUT2
jack
.
appears on the status check screen.
76
(AUDIO SET) by turning the SEL/PUSH EXEC
x
You can adjust levels of signal input from
the INPUT2 jack. This function is effective
only when [INPUT2 LEVEL] is set to
[MIC].
You can select from [0dB], [-8dB] and [-
16dB] (the default setting is [0dB]).
x
This function is effective only when
[INPUT2 LEVEL] is set to [MIC].
jack
.
z Tips
• The INPUT TRIM function adjusts the input
• When recording loud sound, the sound may be
• If you set INPUT TRIM too far to the minus
• Test the effect of the INPUT TRIM function
LINE
Select to input audio signals from an audio
device through the INPUT2
appears on the status check screen.
INPUT2 TRIM
INPUT2 WIND
B OFF
Select to disable wind noise reduction.
ON
Select to enable wind noise reduction.
appears on the status check screen.
level from an external microphone. When using
a highly sensitive microphone or recording loud
sound, set this to the minus side. When using a
less sensitive microphone or recording quiet
sound, set it to the plus side.
distorted at either the input point or the
recording point. If it is distorted at the input
point, adjust the sound using the INPUT TRIM
function. If it is distorted at the recording point,
lower the total volume level manually.
side, the microphone volume becomes too low,
resulting in a poor signal to noise ratio.
according to the microphone used or the sound
field of the recording site before actual
recording.
jack
.