Sony HVR-V1E Operating Manual page 70

Press the MENU button t select the
dial.
b Notes
• Sounds cannot be recorded
• [SMTH SLW REC] settings are automatically
canceled if you turn the power off and back on.
• The shutter speed is automatically set to 1/215
even if you set it to a speed slower than 1/215.
• The recording time may be shorter than the set
time, depending on recording conditions.
• The image quality is lower than with the regular
recording.
.
CNTRST ENHCR
When you set [CNTRST ENHCR] to [ON],
high contrast images, such as backlit scene
images, are detected and unexposed
shadows of the images are automatically
reduced (the default setting is [OFF]).
b Note
• When you set [BACK LIGHT] to [ON],
[CNTRST ENHCR] is temporarily turned off.
PROG. SCAN
You can shoot progressive movies with a
vertical resolution of 1,080 lines.
B OFF
25 (
Select to shoot 25 frames per second,
which is the same as cinema films.
b Note
• Shot movies are converted to the 50i format and
stored.
STEADYSHOT
ON/OFF
x
You can compensate for camera shake (the
default setting is [ON]). Set [ON/OFF] to
[OFF] ( ) when using a tripod (optional),
then the image becomes natural.
70
)
(CAMERA SET) by turning the SEL/PUSH EXEC
x TYPE
You can select the type of the SteadyShot
function that compensates for camera-
shake.
HARD
Select to activate the SteadyShot function
with stronger effect. This mode is not
recommended for recording with camera
pan, tilt technique.
B STANDARD
Select to activate the standard SteadyShot
function.
SOFT
Select to activate the SteadyShot function
so that it leaves a slight unsteadiness on the
picture so the picture looks natural.
WIDE CONV.
Select when a wide conversion lens
(optional) is attached. This mode is the
most effective with Sony VCL-HG0862K
wide conversion lens.
COLOR BAR
ON/OFF
x
You can display the color bar or record it on
the tape by setting to [ON]. It is convenient
to adjust the color on the connected monitor
(the default setting is [OFF]).
b Note
• This is automatically set to [OFF] the next time
you switch on the camcorder.