Maintaining Your Vacuum; Emptying The Dust Cup - Shark IONFlex DuoClean IF200ANZ Series Instructions Manual

MAINTAINING YOUR VACUUM

WARNING: Hand wash
filters only with water
to prevent damage from
cleaning chemicals.
Allow ALL filters to air-
dry completely before
replacing them in the
vacuum to prevent liquid
from being drawn into
electric parts.
CAUTION: Turn off
power and remove
power pack before
servicing.
IMPORTANT: Clean the
dust screen inside the dust
cup as required.
NOTE: Empty dust cup when
debris reaches the MAX fill
line.
RECOMMENDED
FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)

EMPTYING THE DUST CUP

Clean once a month.
1 To empty dust cup, first remove the handheld vacuum from
the wand by pressing the Wand Release button and pulling
up on the handheld vacuum. Position dust cup over a bin,
then open the bottom of the dust cup by pressing the Dust
Cup release button on the side.
15
AUS 1800 099 385 NZ 0800 112 660
FILTER COVER LID
FOAM FILTER
CLEANING THE FILTERS
1 To clean the foam filter, remove the filter cover lid on the top of the handheld vacuum and
slide off the foam filter. Rinse foam filter and filter frame with water. Tap loose dirt off filter
between washes as needed. Once foam filter is completely dry, return it to the filter frame,
then replace the filter frame and the filter cover.
2
To clean the felt filter, remove the cover on the bottom of the handheld vacuum by pressing
the release button. Remove felt filter. Rinse with water. Once completely dry, reinsert the felt
filter and close the filter cover lid.
FILTER FRAME
FELT FILTER
s h a r kc l e a n . c o m . a u
16