Table of Contents
Advertisement
continues to run, an error message is written to the microprocessor. When you enter the
service menu screen where the error occurred, which is written.
.
Oven against any improper operation is protected by a bi-metal type thermal circuit breaker
. Pyro kilns furnaces external cutting bi-metal type thermal oven , left rear upper side of the
frame and the operation temperature is 250 ° C . Inside the oven to a temperature of 350-
400 ° C for the time that is separate from the feed phase conductors . **
* Attention! ! ! ! ! Thermal breaker on the furnace when the furnace at a situation gone
wrong has occurred. ( Such as oven temperature sensor is not working ) replaced with a
new case before generating the error is found and needs to be resolved .
Cooling fan inside the furnace based on temperature ( 120 ° C ± 20 ° C ( 1st step ) , 300 ° C
± 20 ° C ( 2nd stage only pyro ovens are ) between engaged and ground internal to about
160 ° C until it fell work continues. cooling the engine even when the oven after cooking
temperature on the control circuit will continue to operate for a period of time to throw .
Display module consists of Grundıg control card and SMPS.
LED-DISPLAY features explained below.
Display type
Display resolution
Display view angle
Multiplexer ratio or bia
Led controller or driver
Legic voltage
Led driver voltage
Device appropriate temperature range
Storage temperature
Type
Colour
Voltage
Ampere
Brightness ( Back side)
Sensitivity: Public
IBN,BLACK VE TRANSMISSIVE
160X16 DOTS + ICONS
12 0 CLOCK
nokta matriks:
1/20 DUTY. 1/5,3 BIAS "MLS"
S1D15714 + PCF8576D
5.0 V - 0.25V
TBD
-5 C TO + B5 C
-10 C I0 + 90 C
LED01
White
5.0V constant
96 mA typical 120mA max
Minimum
Type
Maximum
-
700
-
42
Advertisement
Table of Contents
