Garmin GTN 750 Pilot's Manual Upgrade Supplement page 31

v5.13 and Earlier or v6.50 and Later
If you build your flight plan with the
destination airport at the end and then
load an approach procedure, you will
navigate all the way to the destination
airport before joining the procedure.
Be sure when LOADING and not
ACTIVATING an approach procedure
that the route to be flown is correct.
8. Touch the Load Approach & Activate key, which makes
the active leg Direct-To the selected transition waypoint, or
for Vector approaches to activate a leg that is an extended
final approach course. You can also "activate" the selected
procedure on the Procedures page, if the approach is not
activated on this page.
Approach Waypoints
Direct-To Waypoint
NOTE: When re-activating an approach, the decision as to whether a hold
is inserted at the IAF or not is assumed to be the same as the first time
the approach was activated, regardless of current aircraft position. If the
pilot wishes to have the hold inserted or removed from the procedure, the
procedure must be re-loaded or activated from the PROC-Approach page.
190-01007-03 Rev. Q
Table 6-2 Loading and Activating an Approach
Figure 6-17 After Activating the Approach
GTN 725/750 Pilot's Guide
v6.00 Through v6.41
If you build your flight plan with the
destination airport at the end and
then load an approach procedure, the
destination airport will be removed from
the end of the flight plan. If the leg to
the destination airport is the active leg
when loading an approach procedure,
you will navigate all the way to the
destination airport before joining the
procedure. Be sure when LOADING and
not ACTIVATING an approach procedure
that the route to be flown is correct.
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
6-13
Index