Creating A Pad Profile - 3Com PathBuilder S200 Series User Manual

Configuration

Creating a PAD Profile

Overview
Follow These
Steps...
6
To create a TPA PAD Profile, select Copy/Insert Record from the Main menu. Using
the Copy Special PAD Profile from PROM function, you can copy default TPA PAD
profiles. There are two default TPA PAD profiles:
• TPA_HOST – (for the Host PAD)
• TPA_RMOT – (for Remote PADs)
Once a default profile is copied, it can then be modified to meet your requirements.
Copying default profiles is the recommended method of creating PAD Profiles
because parameters not needed in polled environments are disabled. TPA PAD
profiles can also be newly created rather than modified by using the Configure PAD
Profile Table function.
To create a new PAD profile:
Step
Select Configure from the Main menu.
1
Select PAD Profile Table from the Configure menu.
2
Main Menu
Configure
PAD Profile Table
Profile Name
#1 PAD Recall
#2 Echo
#3 Data Forwarding Character
#4 Idle Timer Delay
#114 PAD Mode
#115 Data Forwarding Criteria
#116 Short Timer Duration
#117 EIA Signalling Action
#118 Message Assembly
Figure 3. Transparent Polled Async PAD Profile Parameters
Action
Parameters #3, #4, #114
through #118 are used in
conjunction with Transparent
Polled Async
Transparent Polled Async