GreenWorks GS 110 Owner's Manual page 29

TROUBLESHOOTING
PROBLEM
Motor running, but
cutting abnormal.
W A R N I N G
Disconnect the battery pack from the appliance before making any adjustments, changing
accessories, or storing appliance. Such preventive safety measures reduce the risk of starting the
appliance accidentally.
POSSIBLE CAUSE
Motor stops after about 10
seconds.
If the unit cuts off and
beeps during a cut, it went
into protection mode. This
protects the PCB from
damage.
Battery is not charged.
The saw chain needs
lubrication, and will
increase friction if not
properly maintained.
Incorrect battery storage
temperature.
SOLUTION
Recharge the battery.
Release the trigger and restart the chainsaw.
Let the chainsaw do the work and do not force
the cut.
Charge the battery. Refer to the battery
and charger manual for correct charging
procedures.
Make sure the chain is always lubricated by
never letting the bar and chain oil run low.
Allow the battery pack to cool until it drops to
room temperature.
29