Recording Pictures From A Vcr (Dcr-Pc107E); Dubbing Selected Scenes From A Tape; Digital Program Editing - Sony HANDYCAM DCR-PC106E Operation Manual

Recording pictures
from a VCR
(DCR-PC107E)
You can record and edit pictures from a VCR
on a tape inserted in your camcorder via an
i.LINK cable.
Insert a cassette for recording in your
camcorder.
1
Connect your VCR to your camcorder
(p. 62).
2
Slide the POWER switch repeatedly to
select the PLAY/EDIT mode.
3
Set your camcorder to recording pause
mode.
1
Touch
2
Touch [REC CTRL].
3
Touch [REC PAUSE].
4
Start playing the cassette on your
VCR.
The picture played on the connected device
appears on the LCD screen of your
camcorder.
5
Touch [REC START] at the point you
want to start recording.
6
Touch (stop) to stop recording.
7
Touch [ RET.], then
z Tip
• appears when you connect your camcorder
and other devices.
64
Dubbing/Editing
and select [PAGE3].
.
Dubbing selected
scenes from a tape

– Digital program editing

You can select up to 20 scenes (programs)
and record them in the desired order to other
recording device such as VCRs.
Delete unwanted scene
Change the order
Results of editing
Step 1: Preparing your camcorder
and VCR for operation
Follow the steps below when you are
performing Digital program editing for the
first time to a tape in a VCR. You can skip
this setting if you have set up the VCR by the
following procedure before.
b Notes
• You cannot perform Digital program editing on a
VCR that does not support [IR SETUP] codes.
• The operating signal for Digital program editing
cannot be transferred via the LANC jack.
• When your camcorder is connected to the VCR via
the DV Interface, you cannot record the title,
indicators, information for the Cassette Memory.
1
Connect your VCR to the camcorder
as a recording device (p. 62).
You can use either the A/V connecting
cable or the i.LINK cable to make the
connection. The dubbing procedure is
easier with the i.LINK connection.
2
Prepare your VCR.