Basic Operations; Pan/Tilt Operation - Sony EVI-D30 Operating Instructions Manual

Basic Operations

Pan/ Tilt Operation
STD
HOME
L/R DIRECTION
SET
1
Press the POWER button.
The camera will be turned on, performing the
pan/tilt reset action automatically.
2
Press the arrow button to perform the

pan/tilt operation.

While checking the picture on the screen,
press a desired arrow button.
To move the camera inch by inch, press
the button for a moment.
To move the camera in a wide range,
press and hold down the button.
To move the camera diagonally, press
the arrow button (
down the arrow button (
To face the camera back to the front
Press the HOME button.
If you accidentally move the camera
with your hand
Press the PAN-TILT RESET button to reset the
pan/tilt position.
The deviation from the position that the camera
memorizes will be corrected and the operation will
be back in order.
EN
10
1
CAMERA SELECT
REV
2
PAN-TILT
RESET
or ) while holding
or ).
If you wish to face the camera toward
the opposite direction in which the
arrow on a pressed button points
The camera is preset to face toward the right
whenever the arrow (
might wish to face the camera toward the opposite
direction in which the arrow on a pressed button
points, in such a case when you change the
direction of the camera while checking the picture
on the screen. In this case, press the REV button
while holding down the L/R DIRECTION SET
button.
To reset that setting, press the STD button while
holding down the L/R DIRECTION SET button.
Arrow Movement of
button the camera
Note
Repeat the above-mentioned procedure for each remote
commander if you are using more than one remote
commander. This is because the setting is performed by
changing the signal emitted from each remote commander,
not by changing the setting of the camera itself.
If the lamp at the side of the lens
flashes red
The micro computer inside the camera might not
memorize the current pan/tilt position properly.
Press the PAN-TILT RESET button to reset the
pan/tilt position.
Flashes.
) button is pressed. You
Setting
While holding
down
L/R
DIRECTION SET
Press
STD
1
While holding
down
L/R
DIRECTION SET
Press
REV
2