Push Arm - Omega OAL-100 Instalation Instructions

Push Arm:

- Requires cutting of the round bar
- Mount block 14 1/2" from hinge
- Install arm onto spindle as per diagram
- Close door and place round shaft beside tube
- Cut the round rod 2" past last grub screw
- Rod can be slid in out for final adjustment
- Slide rod into position and tighten grub screws
- Remove complete arm from the shaft
- Use jumper wire to "hold open" the motor
- Position the door in full open position
- Typically 90 to 105 degrees
- Reinstall arm onto shaft and tighten screw
(3/16")
- Install safety washer & screw
- Remove jumper wire & adjust magnets
- See "setting the magnets"
safety washer
screw
O M E G A
14 1/2"
tube
A U T O M A T I C S
1 1/2"
4 1/8"
2 1/2"
rod
block
shaft
screw
high mount
low mount
2 0 1 8
V 2 . 0