Using An Ac Adaptor; Using The Anton Bauer Intelligent Battery System - Sony DSR-390L, DSR-390PL Operating Instructions Manual

Using an AC Adaptor

Using a CMA-8A/8ACE AC Adaptor
Connect the camcorder to the AC power supply as
shown in the following figure, and turn the POWER
switch of the CMA-8A/8ACE ON.
POWER switch: ON
LO C
K
CCQX-3 cable
DC IN
Using an AC-DN1 AC Adaptor
Mount the AC-DN1 on the camcorder in the same way
as a battery, then connect to the AC power source.
Note
When power consumption of the camcorder and
accessories is 38 W or higher, use the AC-DN2A/
DN2B AC adaptor (lower than 150 W).
To AC power source
CMA-8A/8ACE
AC Adaptor
CAMERA/CCU
To AC power
source
Using the Anton Bauer
Intelligent Battery System
When using an Anton Bauer battery to power this unit,
set "Menu 206 Selecting Battery Capacity Indication
(see page 120)" according to the battery.
If the Anton Bauer battery supports remaining capacity
indication, a number indicating the remaining capacity
can be displayed in the viewfinder.
Contact your Sony dealer for more information.
Chapter 2 Fitting and Connections
55