Sony DSR-200 Operating Instructions Manual page 91

Symptom
The tape does not move when
a video control button is
pressed.
The Steady Shot function does
not activate.
The autofocusing function
does not work.
The microphone does not
work while recording.
Built-in microphone sound
does not record in stereo when
monitoring by headphone or
line out jacks.
Audio dubbing does not work.
Excessive high-pitched sound
is heard when recording using
the built-in microphone.
The recording sound is weak
or is not heard.
The date and time indicator
disappears.
The overlap function does not
work.
D ZOOM does not work.
D ZOOM mode in the menu
system cannot be set to ON.
The slow shutter does not
work.
Cause and/or Corrective Action
• CAMCORDER/VTR is set to CAMCORDER.
m Set it to VTR.
• The tape has run out.
m Rewind the tape or use a new one. (p. 36)
• The digital camcorder is updating the cassette memory data
(only for DVCAM cassettes with cassette memory).
m Eject the cassette after the C MEMORY indicator
disappears (p. 25).
• STEADY SHOT is set to OFF.
m Set STEADY SHOT to ON. (p. 67)
• FOCUS is set to MANU.
m Set it to AUTO. (p. 52)
• Shooting conditions are not suitable for autofocus.
m Set FOCUS to MANU to focus manually. (p.51)
• LINE/MIC is set to LINE.
m Set it to MIC FRONT or MIC REAR.
• DIRECTION SELECT is set to 0°.
m Set it to 90° or 120°.
• The signal of recording tape is no condition to operate audio
dubbing.
m Dub the tape into another DVCAM cassette in Fs 32k using
A/V connecting cable. (p. 29)
• The picture has been recorded with BUILT-IN MIC set to
WIND.
m When there is no wind, set it to off (green position). (p. 66)
• AUDIO MIX in the menu is set to ST2.
m Set it to ST1. (p. 42)
• Reset the date and time. (p. 79)
• Set DIGITAL MODE to OVERLAP. (p. 44)
• Set DIGITAL MODE to ZOOM and D ZOOM in the menu to
ON. (p. 41)
• Set DIGITAL MODE to ZOOM. (p. 41)
• Set DIGITAL MODE to ZOOM.
(to be contunued)
DSR-200 U/C 3-858-622-22(1). E
91