Sony DSR-200 Operating Instructions Manual page 66

Adjusting the recording sound
To attenuate the recording level
Attenuate the recording level when recording very loud sounds.
• When using the built-in microphone or external microphone.
Set the MIC switch to ATT. Normally set off (green position).
• When connecting an external microphone to AUDIO IN (CH-1/CH-2) input
connector.
Set ATT (REAR) to ON.
To reduce wind noise of the built-in microphone
If there is a loud wind, set the BUILT-IN MIC switch to WIND. Note that low frequency
input signal will weaken.
To change the directionality of the built-in microphone
Set DIRECTION SELECT to the desired position (0°/90°/120°).
When set to 0° the sound is in monaural.
AUDIO IN
66
MIC (PLUG IN POWER)
DIRECTION SELECT
MIC
BUILT-IN MIC
CH-1 LINE/MIC
CH-1 ATT (REAR)
CH-2 LINE/MIC
CH-2 ATT (REAR)
DSR-200 U/C 3-858-622-22(1). E