Table of Contents
Advertisement
Install the louvered docking assembly.
• Docking station must be secured in accordance with these instructions to ensure ice machine
stability.
• Ventilation openings in the louvered docking station should be clear of obstruction
Wall bracket accessory
• Mount louvered docking assembly to wall
bracket accessory
4.1
Undercounter installation requirements for 1000/1400 series
Docking Station: 1000 & 1400 water- and air-cooled models
(See detail drawing on page 12)
• Position and screw louvered docking assembly to the bottom of counter inside of access panel/door 1.75"
(45 mm) from the front edge of the cross brace
• The mounting surface for the louvered docking assembly must be solid. Do not mount directly onto
runners or channels.
• There must be no lip or edge that would hinder the ice machine from sliding in or out of the louvered
➋
docking station
Intake and Exhaust Grille Placement: 1000/1400 air-cooled models only
(See detail drawing on page 12)
• Position the intake grille cut out in the access panel/door
Note: Ice machine must be aligned with cut out and inside of access panel to provide a tight seal and
prevent recirculation of hot exhaust air.
• Left edge of cutout should be 1.75" (45 mm) from the left side of the ice machine
• Bottom edge of cutout should be 1.875" (48 mm) from the bottom of the ice machine
• Position supplied exhaust grille at least 18" (458 mm) away from intake grille
Where possible, install exhaust grille to the rear or side of the base cabinet.
• If not using supplied grille, air circulation requirements below must be met:
1000 series: 150 sq. in (967 sq cm) intake air, 150 sq. in. (967 sq. cm) exhaust air
1400 series: 175 sq. in (1129 sq. cm) intake air, 175 sq. in (1129 sq. cm) exhaust air
HARMONY and Symphony Plus • RIDE Technology
Louvered docking assembly
WARNING
Machine stand accessory
• Mount louvered docking assembly to
➊
machine stand accessory
➌
➎
self-contained
4
➍
11
Advertisement
Table of Contents
