Setup - General PM930SD User Manual

1-1 Liquid-crystal display
1-2 POWER button
1-3 HOLD/ESC button
1-4 REC/ENTER button
1-5 button
1-6 M button
1-7 TIME button
1-8 LOGGER SET button
1-9 Kickstand
1-10 Battery compartment cover

SETUP

1. Choose the power source. Before using the PM930SD, be sure it is powered by fresh
batteries or an optional 9VDC AC adapter plugged into the bottom jack on its right side
(callout 1-14).
To remove the battery compartment cover, remove the two screws holding it in place
(callout 1-11). Then install six "AA" batteries in the correct orientation, using the polarity
marks on the inside of the compartment as a guide. Replace the cover by replacing the
two screws.
2. Install an SD card. To prepare for setup, also install the supplied 2 GB SD memory card
or another card with a capacity from 1 GB to 16 GB in the socket on the bottom of the
PM930SD (callout 1-17). When installing the card, make sure its gold contacts are facing
front and push the card into the socket until you hear a click. To remove the card, push it
in until you hear a click and the card pops out.
Now power on the instrument by pressing the POWER button (callout 1-2) to generate a
short beep. (To power off the PM930SD, press the POWER button and hold it until the
instrument responds with a long beep.)
When the pressure meter powers on, a series of transient startup screens will briefly
appear. Once the display has stabilized, perform the following seven setup steps in the
order presented.
1. Format the SD card. Press the LOGGER SET button (callout 1-8) and hold it for at least
five seconds, until "Sd-F" appears in the lower half of the display. Quickly (within three
seconds) press the REC/ENTER button.
(If you press buttons too slowly in setup mode, the screen will revert to the normal display.
To return to the setup sequence, press and hold the LOGGER SET button again. To move
ahead to the next field in the sequence or to the next parameter, press the HOLD/ESC
button.)
1-11 Battery compartment cover screws
1-12 Tripod attachment nut
1-13 Pressure sensor socket
1-14 Socket for 9VDC AC adapter
1-15 Reset button
1-16 RS232 output jack
1-17 SD card socket
1-18 Pressure sensor port
1-19 Pressure sensor
1-20 Pressure sensor connector
5