Table of Contents
Advertisement
Procedure
Step 1
(Optional) If you are installing a CPU in a socket that had been shipped empty, there will be a protective cap intended to
prevent bent or touched contact pins. The pick and pull cap tool provided can be used in a manner similar to a pair of
tweezers. Grasp the protective cap and pivot as shown.
Figure 12: Protective Cap Removal
Step 2
Release the catch on the pick and place tool by pressing the button/handle.
Step 3
Remove the new CPU from the packaging, and load it into the pick and place tool as follows:
a) Confirm that the pedestal is set up correctly for your processor. The pedestal ships set to the markings "LGA1356-2,"
and this is the correct setting.
b) Place the CPU on the pedestal. The CPU corners should fit snugly at the pedestal corners and the notches should meet
the pegs perfectly.
c) Place the CPU pick and place tool on the CPU pedestal aligned with the A1 arrow pointing to the A1 registration mark.
Make sure the tabs on the tool are fully seated into the slots on the pedestal.
d) Press the button/handle on the tool to grasp the CPU.
17
Advertisement
Table of Contents
