Table of Contents
Advertisement
Cisco UCS Blade Server
Note
Note
# scope server <chassis/server>
# scope boardcontroller
# show image
# activate firmware <boardcontroller version>.0 force
# commit-buffer
See also
Step 7
Do not continue with the next step until the board controller activation completes. Verify whether the
activation is complete by using the show version command.
As shown in the example below, wait until the Activate-Status returns Ready. This process takes a few
minutes before Activate-status is successfully completed and returns Ready.
# show version
BoardController:
Running-Vers: 8.0
Package-Vers:
Activate-Status: Ready
Step 8
Clear the WILL_BOOT_FAULT
a.
In the Navigation pane, click the Equipment tab.
b.
On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose
your server.
c.
In the Work pane, click the General tab.
d.
In the Actions area, click Recover Server.
e.
In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.
Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This
takes two to three minutes. At the end of this process the WILL_BOOT_FAULT is cleared.
Cisco UCS B-Series Servers Upgrade Guide for Intel E5-2600/E5 2400 v2 Series CPUs
6
The server automatically reboots after the
The
command in the sequence below lists the board controller versions available for
show image
the server. Always activate the latest board controller image version when you use the
command.
activate firmware
Sample Board Controller Activation Command Sequence, page
by
commit-buffer
using the Cisco UCS Manager GUI to reset the server CIMC:
command is executed.
15.
OL-28629-02
Advertisement
Table of Contents
