Table of Contents
Advertisement
Hardware Adapter Verification
This section describes how to verify Physical Adapters installed in a Cisco UCS 5108 chassis:
From the Equipment tab of UCSM, choose the appropriate interface card under the Interface Cards of the
server. Refer to Managing Firmware for further UCSM GUI Equipment tab pane functions.
Adapter Hardware Identification
Service Profile Default and Selection of Virtual Interface Placement Interface Adapter Card 2
The Default Virtual Interface Placement section describes how to use the default and selection Virtual
Interface Placement using the Cisco B440−M1 Emulex Adapter Interface Card 2 with UCSM.
Default Virtual Interface Placement
Perform these steps:
1.
Verify hardware for the B440−M1 Emulex Adapter Interface Card 2:
a.
Verify hardware for the B440−M1 Emulex Adapter.
Identify Adapter Type for B440−M1 Interface Cards (slot1 and slot2)
Advertisement
Table of Contents
