Page 1
Suggestions for improvement: Introduction The 1-port serial WAN interface card (WIC-1T) provides serial connections to (256 character limit) remote sites or legacy serial network devices such as Synchronous Data Link Control (SDLC) concentrators, alarm systems, and packet over SONET (POS) Send devices.
Page 2
RS-232, RS-449, X.21 or EIE-530 on the other end depending on your needs Uses the same cabling as Cisco 2500 and Cisco 7000 serial ports. Does not support hot swap, however no hardware damage will occur if it is swapped while the power is on.
Page 3
T and and higher and later higher Note: All parameters mentioned in this table for the Cisco 1700 series routers are also applicable to Cisco 1800 series routers. Configuration This section provides a sample configuration for the WIC-1T interface card.
Page 4
LAN to LAN between 2 ASA5505s Step-by-Step - Sep 18, 2008 Related Information One- and 2-Port Serial and Asynchronous High-Speed WAN Interface Cards for Cisco 1800, 2800, and 3800 Series Integrated Services Routers Cisco Signaling Link Terminals Cisco IOS Release 12.4T feature module Technical Support &...
Need help?
Do you have a question about the WIC-1T and is the answer not in the manual?
Questions and answers