Sony Handycam DCR-SR210E Handbook page 81

The recording media is full. Delete

unnecessary images (p. 38).
Total number of movies or still images

exceeds the recordable capacity of the
media (p. 62, 92). Delete unnecessary
images (p. 38).
While [DROP SENSOR] (p. 69) is

activated, you cannot record images.
You cannot record images in sleep mode.

Cancel QUICK ON (p. 27).
Your camcorder is recording the image you

have just shot onto the media. You cannot
make a new recording during this period.
The temperature of your camcorder is

extremely high. Turn off your camcorder
and leave it for a while in a cool place.
The temperature of your camcorder is

extremely low. Turn off the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.
You cannot record a still image.
You cannot record a still image together

with:
[SMTH SLW REC]

[FADER]

[D.EFFECT]

[PICT.EFFECT]

The ACCESS lamp remains lit even
when you stop recording.
Your camcorder is recording the image you

have just shot on the media.
The recording angle looks different.
Recording angle may vary depending on

the condition of the camcorder. This is not
a malfunction.
The flash does not work.
You cannot use the flash when you capture

still images while recording a movie.
Even if auto flash or

reduction) is selected, you cannot use the
flash with:
(Auto redeye
NightShot

[SUPER NIGHTSHOT]

[TWILIGHT], [CANDLE],

[SUNRISE&SUNSET], [FIREWORKS],
[LANDSCAPE], [SPOTLIGHT],
[BEACH] or [SNOW] in [SCENE
SELECTION]
[MANUAL] in [EXPOSURE]

[SPOT METER]

The actual recording time for movie is
less than the expected approximate
recording time of the media.
Depending on the recording conditions,

the time available for recording may be
shorter, for example when recording a fast
moving object, etc (p. 58).
The recording stops.
The temperature of your camcorder is

extremely high. Turn off your camcorder
and leave it for a while in a cool place.
The temperature of your camcorder is

extremely low. Turn off the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.
If vibrations occur continuously, recording

may stop.
There is a time difference between the
point where you press START/STOP
and the point that movie recording
starts/stops.
On your camcorder, there may be a slight

time difference between the point where
you press START/STOP and the actual
point that movie recording starts/stops.
This is not a malfunction.
The auto focus does not function.
Set [FOCUS] to [AUTO] (p. 73).

The recording conditions are not suitable

for auto focus. Adjust the focus manually
(p. 73).
81