Installing The New Line Cord; Attaching The New Terminal Box Cover - Grundfos Digital timer kit Installation And Operating Instructions Manual

UP_DigitalTimerKit_w_LineCordLid.book Page 6 Wednesday, October 31, 2018 5:49 PM
4.1 Installing the new line cord and
terminal box cover

Installing the new line cord

Connect the new line cord wires to the terminal
box as follows:
1. Insert the new line cord end with wires
through the opening in the side of the
terminal box. Push the cord end through the
opening with the flat side up. See fig. 5.
2. To lock the cord end in place, twist the end of
the cord a half turn so that the flat side of the
cord end is at the bottom. See fig. 5.
3. Press down the tab marked with the symbol
, or ground, while inserting the end of the
green wire into the slot. See fig. 6. Release
the tab to lock the green wire into place.
4. Press down the tab marked "N" or Neutral,
while inserting the end of the white wire into
the slot. Release the tab to lock the white
wire into place.
5. Press down the tab marked "L" or Line, while
inserting the end of the black wire into the
slot. Release the tab to lock the black wire
into place.
1
2
Fig. 5 Inserting the new line cord into the
terminal box
Fig. 6 Connecting the new line cord wires
Line cord
end
Fig. 7 Overview of new line cord wires
after installation
6

Attaching the new terminal box cover

1. Insert and tighten the two screws at the
corners of the outside of the pump's old
terminal box lid. See fig. 8.
Fig. 8 Insert and tighten the two screws to
attach the new terminal box cover