Sony Handycam DCR-HC90 Operating Manual page 11

4
Slide the POWER switch up to
OFF (CHG). (The default setting.)
/CHG (charge)
lamp
5
Connect the AC Adaptor to the
DC IN jack on your camcorder.
The  mark faces right
6
Connect the power cord to the AC
Adaptor and the wall outlet.
The CHG (charge) lamp lights up and
charging starts.
7
The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor
from the DC IN jack on your
camcorder.
Disconnect the AC Adaptor from the
DC IN jack holding both the camcorder
and the DC plug.
To remove the battery pack
Turn off the power. Open the battery/
"Memory Stick Duo" cover, then press the
battery release lever in the direction of the
arrow  to remove the battery pack.
When storing the battery pack
Fully discharge the battery before storing it
for an extended period (p. 108).
To use an outside power source
You can operate your camcorder using the
power from the wall outlet by making the
same connections as you do when charging
the battery pack. The battery pack will not
lose its charge in this case.
POWER switch
2
1
Battery release lever
Continued 
11