Sony Handycam DCR-DVD408 Operating Manual page 23

To remove the battery pack
1 Turn the POWER switch to OFF (CHG).
2 Raise the viewfinder.
3 Press the BATT (battery) release button
and remove the battery pack.
b Notes
• When you remove the battery pack or the AC
Adaptor, make sure that the
(Still) lamp (p. 25) is turned off.
When storing the battery pack
Fully discharge the battery before storing it
for an extended period.
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
BATT (battery)
release button
(Movie) lamp/
pressing DISP/BATT INFO again while the
information is displayed.
Remaining battery (approx.)
Recording capacity (approx.)
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
Battery pack
NP-FH50
NP-FH60
(supplied)
NP-FH70
NP-FH100
Recording time
Approximate time (min.) available when
you use a fully charged battery pack.
DCR-DVD408/DVD808
Continuous
Battery pack recording
time
NP-FH50
NP-FH60
(supplied)
NP-FH70
NP-FH100
Charging time
135
135
170
390
Typical
recording
time*
75 35
80 40
80 40
100 50
105 50
105 50
160 80
170 85
170 85
375 185
395 195
395 195
23
Continued ,