Dell EqualLogic PS4000 Series Instructions Manual page 10

2. Orient the mounting rail in its proper position. Each rail is stamped with either "LH Front" or "RH
Front." When the rails are properly positioned, the brackets are closer to the rear of the rack and
pointing up. See Figure 2.
3. Attach the front of the rail to the inside of the front pole (Figure 3, callout
screw, one spring washer, and one plain washer from the COMMON bag.
4. Pull the rear flange until it meets the inside surface of the rear rack pole. See Figure 2.
Make sure the locator pins go through the rack holes at the same height (in the same relative holes on
the front and rear poles), according to the pole markings, if present. Use a level to make sure the rails
are level.
5. Attach the rear of the rail to the rear pole (Figure 3, callout
spring washer, and one plain washer from the COMMON bag.
Figure 3 Attaching a Mounting Rail to the Front and Rear Poles
6
Figure 2 Adjusting the Length of a Mounting Rail
) using one Phillips head
) using one Phillips head screw, one
PS4000 Rack Mount Instructions