Remote Control - Amcor AC12 User Manual

FEATURES AND OPERATION
SLEEP MODE
While in cooling pressing the "SLEEP" button will put the unit in sleep mode.
The fan speed will change to low.
It will automatically increase the desired temperature by 1℃ after an hour and by a further 1℃ after a
further hour. This means the unit will spend less time with the compressor running, and so run
quieter.
The sleep function cannot be used in dehumidify and fan modes.
If the water tank is filled, the unit is put into standby or the mode is changed, sleep mode will be
cancelled.
SWING MODE
After machine turns on, press the "SWING" button, the inner louver will swing continuously left
and right; by pressing the button again the movement will stop and the louver remain in that
position.
COMPRESSOR PROTECTION
There is a 3 minutes compressor start delay after power on or restart.

REMOTE CONTROL

1. Power
: Press to turn the unit on/off.
2. TIMER
:Press to set the timer. Once set, selected
duration will flash 5 times as confirmation. Under power-on
or standby mode, press this button to setup the on/off
timer between 1~24.
3. Down
: Press to decrease the desired temperature, or
the timer duration after pressing the timer button.
4. Mode
: Press to choose between cooling, heating
(AC12HP only), dehumidifying or fan modes.
5. Up
: Press to increase the desired temperature, or the
timer duration after pressing the timer button.
6. Fan
: Press to change between low/medium/high fan
speeds.
: (Only in cooling mode) ：Press to enable sleep
7. Sleep
mode.
8. Swing
: Press to control swing function.
The air conditioner responds to all signals that are sent by
the remote control. Two AAA-batteries are required to use
the remote control.
Note: the air flow direction cannot be adjusted with the
remote control.
IMPORTANT:
There is a 3 minutes delay on power on. In order to protect the life of the
compressor and electronic components please do not switch on the unit for at least
5 minutes after you turned the unit off.
8