1. Manuals
  2. Brands
  3. Aspire Manuals
  4. Vaporizers
  5. CE6
  6. Instructions

Aspire CE6 Instructions

Personal vapouriser
Hide thumbs
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
Congratulations on your purchase of this eCigarette Starter kit! The following are some basic instructions on
handling, use and care of your eCig Starter Kit equipment. Please read this guide completely before using
your device.
Please also ensure the batteries are fully charged before your first use. The battery is locked when
shipped (see charging and unlocking instructions below).

General Kit contents

eGo/510 compatible Normal or Variable Voltage (either 4 click VV or VV Twist) batteries
clearomisers AKA Tank to fill eliquid
USB charger lead with LED indicator
Australian wall plug for USB cable depending on Kit or buy as an extra optional
eliquid optional extra
Carry case

How to Filling/Refilling the clearomiser

CE6 / CE5 / GT are Top filling clearomiser i.e. you take out mouth piece and fill it from there. Where
as Protank, Aerotank, Nautilus etc are bottom filled clearomiser
Unscrew the clearomizer from the battery if your kit has arrived assembled. Always screw/unscrew
clearomisers from their base rather than the main body. Then unscrew the clearomiser mouthpiece.
Drip or syringe 1.6ml maximum (less if refilling as wick holds some juice even when the clearo is empty) into
the tank while holding it at an angle slightly off vertical. Do not fill past the 1.6ml mark and do not allow
liquid to enter the hole on the center post inside the clearomiser.
Once filled, screw the mouthpiece back on, being careful not to cross thread or over-tighten.

Assembly

Screw the clearomiser into the battery. Be careful not to cross thread or over-tighten.
NOTE: Over-tightening chargers, clearomizers and atomizers can damage a battery. Carefully screw on
these components until you begin to feel resistance; then apply a maximum further one-quarter turn.

General Usage

For more guides, hints and tips; visit www.eCigWorld.com.au
eCigWorld CE6 / CE5 PERSONAL VAPOURISER INSTRUCTIONS
www.eCigWorld.com.au

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CE6 and is the answer not in the manual?

Questions and answers

Related Manuals for Aspire CE6

Summary of Contents for Aspire CE6

  • Page 1 Carry case How to Filling/Refilling the clearomiser CE6 / CE5 / GT are Top filling clearomiser i.e. you take out mouth piece and fill it from there. Where as Protank, Aerotank, Nautilus etc are bottom filled clearomiser Unscrew the clearomizer from the battery if your kit has arrived assembled. Always screw/unscrew clearomisers from their base rather than the main body.
  • Page 2 "normal" setting is 3.6V (blue). Variable voltage using Twist Nob at the bottom - VV Twist / Vision Spinner / Aspire CF Batteries Variable voltage Twise batteries have a nob dialer at the bottom of the battery which can be turned/ twisted to set it at desired voltage setting These batteries are lot easier to change the voltage setting.
  • Page 3 Changing atomizer heads CE5/ CE6 / GT The atomizer head inside the clearomizer should last a couple of weeks under fairly consistent use. Once vapour production decreases or juices start tasting a little odd;...
  • Page 4 How to use eGo CE6 / CE5 / EVOD tank (clearomizer) e­cigarette. a. How to change the coil head on eGo CE6 cartomizer(Clearomizer): Step 1: Unscrew the eGo CE6 clearomizer tube from eGo CE5/CE6 clearomizer base. Step 2: Unscrew the eGo CE5/CE6 clearomizer coil head from the top of the base assembly. Step3: Screw the new eGo CE5/CE6 clearomizer coil head into the CE5/CE6 clearomizer base again; Step4: Screw the CE6 clearomizer tube back into the eGo CE5/CE6 clearr base. Tips: the cartomizer coil head may be loosed with the cartomizer base, if so, please re­screw it in the cartomizer base again. b. How to fill e­liquid to the eGo CE6 cartomizer(clearomizer): Step 1: Take out the e­liquid bottle lid; Step 2: Cut off the top of bottle; Step 3: Unscrew the CE6 clearomizer tip from the CE6 clearomizer  tube.
  • Page 5 Activate the battery by click the button 5 times. It will turn the battery ON (To Turn it OFF press the button 5 times). Once battery is on, it will fire every time button is pressed. Now to start vaping press the LED button and inhale at the same time. d. How to charge the eGo CE6 battery: You just screw the eGo battery with the USB charger, then plug it into the PC or AC­USB Adapter. 1. the first charge should be ...

This manual is also suitable for:

Ce5

Table of Contents