Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Komfovent Ping2
Summary of Contents for Komfovent Ping2
- Page 1 Installation Manual...
- Page 2 TABLE OF CONTENTS INTRODUCTION .......................... 3 1. NETWORK MODULE CONNECTIONS ................... 3 2. NETWORK MODULE INSTALLATION ..................3 3. EXAMPLES OF NETWORK CONNECTION ................5 4. “PING2“ MODULE CONFIGURATION..................6 UAB AMALVA we reserve the right to make changes without prior notice.
- Page 3 Network module “Ping2” is intended for connection of KOMFOVENT air handling units to the computer network (Ethernet) or another network (“RS-485”). If “Ping2” module is not added by factory, it can be installed on each air handling unit (AHU) with C3 or C4 controller. For this case user need to have installation kit: 1.
- Page 4 3. Disconnected from the panel cable connect to the “Ping2” module J1 socket: 4. Connect one end of the cable from installation kit to the panel and another end to J2 socket of “Ping2” module: 5. If AHU is connected to the computer network, standard CAT5E UTP cable is connected to “Ethernet” socket: 6.
- Page 5 3. EXAMPLES OF NETWORK CONNECTION Connection through “Ethernet” network Picture 3 a Connection through “RS485” line Picture 3 b UAB AMALVA we reserve the right to make changes without prior notice.
- Page 6 PC is needed. CONNECTION 1. Plug one end of the network cable into the “Ping2” module and the other end to the computer. 2. Go to the properties of your network card and enter IP address, e.g. 192.168.0.200, and subnet mask 255.255.0.0.
- Page 7 “Reset” jumper Picture 4 a Picture 4 b Following the above steps the connection parameters of “Ping2” will be restored to default (4 c Picture). Default connection parameters Picture 4 c UAB AMALVA we reserve the right to make changes without prior notice.
- Page 8 UAB AMALVA Ozo str. 10, LT–08200 Vilnius, Lithuania info@amalva.lt www.amalva.com www.komfovent.com 2013...
Need help?
Do you have a question about the Ping2 and is the answer not in the manual?
Questions and answers