Charging Battery Pack - Sony CX115E Operating Manual

You can charge the "InfoLITHIUM" battery pack (V series) after attaching it to your
camcorder.

Notes
You cannot attach any "InfoLITHIUM" battery pack other than the V series to your camcorder.

1
Turn off your camcorder by closing the LCD screen.
2
Attach the battery pack by sliding it in the direction of the arrow until it
clicks.
3
Connect the AC Adaptor and the power cord (mains lead) to your
camcorder and the wall outlet (wall socket).
Align the  mark on the DC plug with that on the DC IN jack.

The CHG (charge) lamp lights up and charging starts. The CHG (charge) lamp turns off
when the battery pack is fully charged.
4
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
Tips

See page 68 on recording and playing time.

When your camcorder is on, you can check the approximate amount of remaining battery power with the

remaining battery indicator at the upper left on the LCD screen.
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever () and remove the battery
pack ().
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 1: Charging the battery pack. " Even if the battery pack is
attached, the battery pack is not discharged.
GB
13