Table of Contents
Advertisement
Brief instructions
Filling the salt reservoir
When filling the salt reservoir only
open the door halfway to ensure
that all the salt gets into the reservoir.
Press the button on the lid of the salt
reservoir in the direction of the arrow
until the flap springs open.
Lift up the funnel.
Dishwasher detergent will
damage the water softener.
Do not fill the salt reservoir with
powder or liquid detergent.
Do not fill the reservoir with water.
Add dishwasher salt only until the
reservoir is full or until water runs out
of the opening.
Clean any excess salt from around
the reservoir opening and then close
the flap.
Immediately after filling the salt
reservoir, run the QuickPowerWash
programme with the Short
programme option selected and
without any crockery in the
dishwasher to remove any traces of
salt from the cabinet.
Adding rinse aid
Press the button on the lid of the
rinse aid reservoir in the direction of
the arrow until the flap springs open.
Add rinse aid only until it is visible in
the opening.
Close the flap firmly. It should click
into place.
Wipe up any spilled rinse aid. This
prevents over-foaming occurring
during the next programme.
Load the dishwasher
Adding detergent
Follow the dosage recommended by
the manufacturer on the packaging.
Press the opening catch on the
detergent dispenser. The flap will
spring open.
The flap is always open at the end of a
programme.
Add the required amount of detergent
and close the flap.
Switching on the dishwasher
Turn on the tap if it is turned off.
Open the door.
Switch the dishwasher on using the
button.
The main menu will appear in the
display.
If the
Memory
function is selected, the
last programme selected will appear in
the display instead of the main menu.
Selecting a programme
Use the arrows to select the
programme required.
The display will change to show the
programme menu.
Advertisement
Table of Contents
