Advertisement
CLEANING THE COLLECTION CELL
1. Turn the air conditioning system off at the Comfort
Control and turn off service disconnect.
2. Remove top furnace door.
3. Slide COLLECTION CELL out of Furnace.
CLEANING
The COLLECTION CELL may be cleaned either by
vacuuming (recommended method) or by washing.
VACUUM CLEANING
Remove the COLLECTION CELL from the condi-
tioned space before vacuuming. Vacuum both sides of
the COLLECTION CELL to clean.
WASHING
Use low-pressure water spray, such as a sink sprayer
or garden hose to clean the COLLECTION CELL.
Some residue may require warm water to be re-
moved.
• Do NOT use soap or detergent in cleaning
the COLLECTION CELL.
• Do NOT immerse the COLLECTION CELL
completely in water.
• Do NOT place the COLLECTION CELL into
a dishwasher to clean.
• ALLOW THE COLLECTION CELL TO DRY
THOROUGHLY BEFORE REINSTALLING.
Slightly tap the COLLECTION CELL to remove water re-
tained in the filter. Allow the COLLECTION CELL to dry
thoroughly before reinstalling.
CLEANING THE FIELD CHARGER
▲
CAUTION
!
FIELD CHARGER PINS ARE SHARP. DO NOT BEND
FIELD CHARGER PINS. WEAR APPROPRIATE GLOVES
WHEN HANDLING THE FIELD CHARGER.
1. Turn off the Comfort Control and the service dis-
connect.
2. Turn off power to the Furnace and remove the top
furnace door panel.
3. Remove COLLECTION CELL.
4. Remove the inner blower door panel by removing
four screws.
5. Disconnect green return wire and red high voltage
wire. To remove high voltage wire, twist and pull
connecter apart.
6. Remove the two 5/16" hold down screws at the front
center.
7. Lift up the front of the FIELD CHARGER and slide
forward to remove from the case. Lay the FIELD
CHARGER on a secured flat surface.
8. Wipe down the face Plate of the FIELD CHARGER
with a dry shop towel or use a vacuum cleaner. Do
not disassemble the FIELD CHARGER.
18-CD24D1-2
Installer's Guide
Figure 19
Figure 20
NOTE: Do NOT use water, soap, detergent, or chemicals
to clean the FIELD CHARGER.
9. To clean pins, push a block of foam down over the
FIELD CHARGER Pin.
10. Rotate the foam block on the FIELD CHARGER
Pin.
11. Use the foam block to clean the faceplate opening
edges.
12. Repeat steps 9 and 10 for each FIELD CHARGER
Pin.
13. Reverse steps to reassemble the air cleaner. The
inner blower door MUST be reinstalled.
27
Advertisement
