Displaying And Maintaining Track Object(S) - H3C S5500-EI Series Operation Manual

Operation Manual – Track
H3C S5500-EI Series Ethernet Switches
Follow these steps to configure the Track-Static Routing collaboration:
Enter system view
Configure the Track-Static
Routing collaboration, so
as to check the
reachability of the next
hop of the static route
Note:
For the configuration of Track-Static Routing collaboration, the specified static route
can be an existent or nonexistent one. For an existent static route, the static route
and the specified Track object are associated directly; for a nonexistent static route,
the system creates the static route and then associates it with the specified Track
object.
The Track object to be associated with the static route can be a nonexistent one.
After you use the track command to create the Track object, the association takes
effect.
If a static route needs route recursion, the associated Track object must monitor the
next hop of the recursive route instead of that of the static route; otherwise, a valid
route may be considered invalid.
For details of static route configuration, refer to the Static Routing Configuration part
in IPv4 Routing Configuration.

1.5 Displaying and Maintaining Track Object(s)

Display information about
the specified Track object
or all Track objects
To do...
system-view
ip route-static
dest-address { mask |
mask-length }
next-hop-address track
track-entry-number
[ preference
preference-value ] [ tag
tag-value ] [ description
description-text ]
To do...
display track
{ track-entry-number | all }
Use the command...
Use the command...
1-5
Chapter 1 Track Configuration
Remarks
—
Required
Not configured by default.
Remarks
Available in any view