Table of Contents
Advertisement
Figure 2-10. Lower Magazine Throat
II------SIDE JOGGLER
• 000" to • 005"
CLEARANCE
2" CARD DECK
Figure 2-10A. Side Joggler Adjustments
2-8
LATCH
CLUTCH OPERATING LEVER
III~I+--- ELONGATED HOLE
The picker knives travel in an arc and not in a
flat plane parallel to the card line. For this reason,
to obtain the best possible feeding conditions, the
knife blocks must travel evenly through the same arc.
The knife blocks are factory adjusted and should never
be
changed.
~.
Each picker knife block is fixed on its arm~~ITwo
carballoy pieces are inserted in the block surface to
resist wear. The inserts are ground to specifications
for knife projection and replacement of the picker
block is required when the insert becomes worn.
Adjustments
1. Position picker knife cam followers for a
maximum of .004" clearance over the entire pe-
riphery of the cams, without binding.
2. Shim hopper posts on mounting bar for a
clearance of .010" to .015" between hopper posts and
a pack of cards restingagainstthethroatknife. (The
file feed front joggler must be adjusted first.)
Advertisement
Table of Contents
