Table of Contents
Advertisement
CARD RESTRAI NI NG
ASSEMBLY
GUIDE
ASSEMBLY
CARD DECK
SUPPORT
STACKER STOP
SWITCH
Figure 3-5. stacker Schematic
Stacker Joggler Adjustments
CARD PUSHER
SLIDE
1. The three shaft must be free of binds (align the
four bearing bracket assemblies).
2. Maintain 4.000"
±
.005" between the bases of
the two inside bearing brackets (Figure 3-7).
3. With the center shaft assembly shifted toward
the
reader feed and the clutch hubs flush with the
spring sleeve. adjust the clutch hub (identified by a
red dot) for .003" to .005" clearance while its spring
sleeve is flush against the mating hub.
HUB IDENTIFIED WITH RED
HELICAL
MATI NG HUB
CARD ALIGNMENT LEVER
4 - 6 CARDS
ECCENTRIC TO
JOGGLE CARD
TO FRONT OF MACHI NE
Stacker Adjustments
1. Make sure all sliding and pivoting parts move
freely with no binds.
2. The space between the pocket separators
should be 3 5/16"
±
1/64".
3. The pocket separators should be square with
transport rails within .015".
4. Form the radial guide as shown in Figure 3-6.
HELICAL SPRING SLEEVE
READ FEED END
1 ~ . ~ _ _ _ F _ L _ U _ S _ H ~
___
~
____
. O : : ~ : : H _ ~ _ : : _ : _ 5
________
. ~ ~ 1
MOUNTING BRACKETS
Figure 3-7. Center stacker Joggler Assembly
3-3
Advertisement
Table of Contents
